20
14K160TH OTR Body & Air Compressor Manual # 99903184
ROLL-UP DOOR PROCEDURE:
1
CLAMP VERTICAL RAILS (#80) INTO PLACE. DO NOT INSTALL AT THIS TIME.
2
INSTALL DOOR HEADER. CENTER BETWEEN VERTICAL JAMS.
3
UNCLAMP VERTICAL RAILS (#80 AND PLACE OFF TO SIDE.
4
INSTALL COUNTERBALANCE ROLLER BRACKETS.
5
INSTALL HORIZONTAL RAILS (#85).
6
INSTALL COUNTERBALANCE ROLLER (#79). PAY CLOSE ATTENTION TO TO THE WRAP DIRECTION
DECAL.
7
UNROLL SLATS ON ROLL-UP DOOR (#86) WHILE FEEDING IT INTO THE RADIUS CORNER
COMPONENTS.
8
INSTALL THE THREE SHUTTER STRAPS ONTO THE COUNTERBALANCE ROLLER. INSTALL ONE STRAP
IN THE MIDDLE OF THE COUNTERBALANCE ROLLER. INSTALL THE OTHER TWO STRAPS THREE
INCHES FROM EACH END.
9
PULL NAIL ON THE COUNTERBALANCE ROLLER. THIS WILL CREATE TENSION TO HELP THE DOOR
ROLL UP.
10
INSTALL THE VERTICAL RAILS (#80). LEAVE DOOR DOWN A FEW INCHES AND ANGLE DOOR BACK
ENOUGH TO ALLOW VERTICAL RAILS (#80) TO SLIDE INTO PLACE.
11
INSTALL FLIPPER CATCHES (#82). THE RUBBER ON THE BOTTOM OF THE DOOR MUST BE
COMPLETELY FLAT WHEN THE DOOR IS SHUT.
12
INSTALL THE HANDLE (#75). DRILL HOLES IN DOOR FOR INSTALLATION.
13
ADJUST THE CABLE LENGTH WITH THE TURN BUCKLE. MAKE SURE THE CABLE IS JUST TIGHT
ENOUGH TO ALLOW PADDLE HANDLE LOCKS TO COMPLETELY OPEN. TIGHTEN DOUBLE NUTS.
14
INSTALL ALUMINUM PROTECTIVE COVER. USE COVER AS A TEMPLATE TO DRILL HOLES. USE #7 CAP
SCREWS AND #5 NYLOC NUTS.
15
APPLY DOOR LUBRICANT. MAKE SURE ALL DEBRIS IS OUT OF DOOR RAILS AND RUBBER SEALS
BEFORE APPLYING LUBRICANT.
16
APPLY WHITE PERFLEX SEALANT BETWEEN COMPARTMENT AND ROLL-UP DOOR.
