14
How the Machine Works
The Burnish components of the machine are:
Burnish pad holder
Burnish pad
Burnish motor
Dust Collection Bag
As the machine moves forward, the burnish pad shines the floor. Any excess dirt or wax gets picked up
by the pad and distributed into the dust collection bag via the dust collection system.
Pre-Operation Checklist
Before operating the machine:
Check that the Burnish Switch is in the off position.
Check the pad holder to ensure there are no breaks or cracks.
Check correct connection of the batteries.
Check that the Dust Collection Bag is empty.
elease caster breaks.
Turning on the Machine
1. Complete pre-operation check.
2. Turn the Key to the ON position.
3. Turn on the burnish switch and engage the handle levers.
4. Adjust speed as needed with traction speed control knob. (Traction Models Only)
Changing Direction
When the handle levers are engaged the machine will travel in the forward direction. To travel in reverse,
while the handle levers are engaged, hold down the reverse switch. The machine will change from
forward direction to reverse direction. The machine will continue in the reverse direction until the reverse
switch is released.
Stopping and Turning Off Machine
To stop the machine, release the handle levers and the machine will smoothly brake to a stop and after 3
seconds the burnish motor will stop. When turning the machine off, turn off the burnish switch and then
turn off the key switch.
Installing/Changing Burnishing Pad
1. Make sure the Burnish Switch is OFF.
2. Lift on the front of the deck and tilt deck into the pad change position.
3. Remove the center device by turning counterclockwise and carefully remove the old pad from
the Velcro material.
CAUTION!
CAREFULLY INSPECT THE PAD HOLDER
FOR CRACKS OR DAMAGE! Replace if necessary .
Summary of Contents for BB20N
