Clean the dirty water tank
Check that the suction filter is undam
-
aged and clean
Check that the detergent outlet filter is
undamaged and clean
Clean the brushes
Check that the squeegee is clean and the
blades are not damaged
REPLACING THE SQUEEGEE BLADES
•
Open the clip (Ref. 1).
•
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting
them.
•
Remove the blade.
•
Reuse the same blade by reversing the edge in contact with the floor until all four
edges are worn out, or replace with a new blade, fitting it onto the pins on the body
of the squeegee.
•
Reposition the two blade retainers by centring the widest part of the slots over the
fixing pins on the squeegee body, then pushing the blade retainers inwards.
•
Fasten the clip.
•
Put the squeegee back on its support, following the instructions described previously.
ATTACHING/REMOVING THE BRUSHES
Position the brush underneath the head, in the centre (single-brush floor scrubber), position the brushes underneath the head on
both sides (double brush scrubber), switch the machine on.
Pressing the ATTACH/RELEASE button once after starting the machine releases the brushes, pressing the button a second
time activates automatic brush attachment. The button is only enabled when all the functions are deactivated (suction motor and
brushes).
IF THE MACHINE IS NOT USED FOR AN EXTENDED PERIOD, UNPLUG THE EMERGENCY CONNECTOR
TO AVOID DISCHARGING THE BATTERIES.
1
2
1
2
