ENGLISH
8
5.
HANDLING AND INSTALLATION
5.1.
Lifting and transporting the packaged machine
IMPORTANT
During all lifting operations, make sure the packaged machine is firmly anchored to
avoid it tipping up or being accidentally dropped.
Always load/unload lorries in adequately lit areas.
The packaged machine must be loaded using suitable equipment (see EC Directive
2006/42/CEE and subsequent amendments and/or additions) onto the transporting
vehicle. At destination, it must be unloaded using similar means.
A fork lift truck must always be used to lift the packaged body of the machine. Handle
with care to avoid knocking or overturning the machine.
5.2.
Checks on delivery
When the carrier delivers the machine, make sure the packaging and machine are both
whole and undamaged. If the machine is damaged, make the carrier is aware of the
damage and before accepting the goods, reserve the right (in writing) to request
compensation for the damage.
5.3.
Unpacking – Assembly
IMPORTANT
When unpacking the machine, the operator must be provided with the necessary
personal protection devices (gloves, goggles, etc) to limit the risk of accident.
Unpack the machine as follows:
• cut and remove the plastic straps using scissors or nippers;
• remove the cardboard;
• clean the outside of the machine in respect of safety regulations;
• move the machine away from the packaging and install the various components
following this sequence:
1. extract the two tanks from the chassis.
2. remove the lid from the tank
3. extract the squeegee raising lever from the tank
4. mount the squeegee raising lever using the screw, nut and washers provided (fig.
B, ref. 1).
5. position the detergent tank on the chassis and connect the detergent tank
hydraulic circuit to the hydraulic circuit of the machine (fig. C, ref. 1).
6. mount the lid on the detergent tank (fig. D).
7. install the filter on the detergent tank lid (fig. D).
8. fit the dirty water tank on top of the detergent tank (fig. D)
9. block the dirty water tank as follows:
•
lift the dirty water tank (fig. S, ref. 1) and lean it towards the front of the machine.
•
rotate the detergent tank (fig. S, ref. 2) handle (fig. S, ref. 3).
•
insert the handle (fig. S, ref. 3) into the hook on the dirty water tank (fig. S, ref.
1).
•
rest the dirty water tank (fig. 2, ref. 1) on the detergent tank (fig. S, ref. 2).
10. rotate the cowling (fig. D, ref. 1) .
11. extract the dirty water tank lid and mount it on the tank (fig. D).
12. rotate the detergent tank tap lever to open (fig. C, ref. 1)
13. release and adjust the handle using the two knobs (fig. D, ref. 2).
14. install the battery, respecting the safety instructions given in the manual (fig. E,
ref. 1).
15. Fit the two suction hoses to the dirty water tank lid (fig. F, ref. 1).
Summary of Contents for G25B
Page 1: ...ENGLISH ...
