2
FUNCTIONS OVERVIEW AND MANAGEMENT
2
FUNCTIONS OVERVIEW AND MANAGEMENT
2.7 Remote Access
2.7 Remote Access
very files and copying them in bulk.
Figure 7: FTP settings
The
FTP Access
is switched off in the default configuration. You can allow it by ticking the
Enable FTP access
checkbox and confirming the changes by clicking the
Apply Changes
button. The user name for FTP is in
default set to “ftp”. When using FTP access for the first time, it is necessary to choose a password for FTP
access in the FTP Password section. The password may also be later changed here, if necessary.
The
FTP Access
does not allow the user to delete the old recordings manually. Erasing of the old data is only
possible through the function
Purge data older than
... available in the
Storage section
.
2.7
Remote Access
If you want to access the IPCorder and its subordinate devices remotely from other networks (i.e. via Internet),
it is necessary to configure the so-called
Remote Access
. For making this possible, the local network in which
the IPCorder is connected must contain a router (Internet Gateway) capable of translating addresses.
In the menu
Management – Configuration – Remote Access
(Figure 8), you first need to allow the remote
access by clicking the
Enable remote access
checkbox. Depending on the characteristics of the router that is
being used, it is then mandatory to choose from the two possible ways of access to the device.
•
Automatic router control
– If the router that is being used supports the UPnP (Universal Plug and Play)
protocols, the IPCorder can control the remote access dynamically, with no need to configure it manually.
13
Summary of Contents for KNR-090 4
Page 1: ......
Page 2: ...IPCorder User Manual 1 4 Copyright c KOUKAAM a s 2011...
