IPCorder KNR-200/202/206
IPCorder KNR-200/202/206
Quick Installation Guide
Quick Installation Guide
it is finished and then restart to normal mode.
While rescue mode is running, the red exclamation mark on
the front panel will blink.
•
After a while you should see the normal login window. Default user name is
admin
, password
admin
.
•
After the first login you will see
Configuration Guide
which leads you through basic IPCorder settings. You
can also let the IPCorder to find the cameras in your network and setup their recording options. All these
actions are accessible via the
Settings
menu.
•
For optimal function of IPCorder it s recommended to have latest stable version of firmware installed. Therefore
before using IPCorder for the first time it is recommended to check if there is not any newer version of firmware
available. The description is available in the
User manual
under
Firmware Upgrade
section.
3. LED signalization and button actions
IPCorder KNR-200/202/206 front panel contains 5 signal LEDs:
Net
lights when a network cable is connected,
blinks on network activity. Two
Disk
LEDs blinks on individual disks activity. Signification of
Power
and
Info
LEDs
is described in the following table:
status
Power LED
Info LED
short press
long press
very long press
power supply connect
—
—
start
factory reset
—
off
—
—
start
start
—
normal mode
on
off
rescue mode
shutdown
hard shutdown
rescue mode
off
on
normal mode
shutdown
hard shutdown
starting
blinking
off
found by Discover
on
blinking
factory reset running
on
fast blinking
This IPCorder model has only one control button so it recognizes 3 press types. For easier press-type indication there
is a
small green LED
at the back cover. On
short press
the LED lights. On pressing for more than 5 seconds the
LED starts blinking and signalizes
long press
. If we press the button for a 15 seconds, LED will start to blink faster
and signalizes
very long press
.
3
