LIP-9002 User Guide - ST
7
headset jack. The LIP-9000 phones are compatible with several
headsets. Please consult with your local Ericsson LG-Enterprise
representative for a list of headsets compatible with the LIP-9000.
6. The phone includes a foot stand that can be installed to provide a 30
0
or 60
0
angle of the face of the phone. If the phone is not wall mounted,
install the foot stand at the desired angle. If wall mounting, do not
install the foot stand.
NOTE
Once installation is complete, the phone may require configuration of the
network parameters before becoming operational. These parameters
should be modified by a trained technician only. Refer to
9.3 Network
Configuration
1.5.1
Wall Mount
for additional details.
The LIP-9002 phone can be wall mounted. The following instructions
describe how to perform a wall mount installation.
1.
If installed, remove the foot-stand
from the Phone.
2.
Connect all wiring to the Phone as
described in 1.5 LIP-9002 Phone
Installation. Connect the Phone side
wiring only.
3.
Align the wall-mount bracket (not
included) over the back of the phone,
then press the bracket forward
applying steady pressure until it
clicks into place.
4.
Mark and drill two 7mm holes for plastic wall anchors (not included).
5.
Insert the two anchors into the holes, and insert and tighten the two
screws leaving about 2.5 mm (1/8-inch) exposed.
6.
Align the key holes in the bracket over the screws and slide the LIP-
9002 phone down assuring the phone is secure.
7.
Remove, reverse and re-install the handset hook so that the hook
catches the groove in the handset receiver.