10
5. Skalierung der Anzeige
5. Scaling
procedure
5.1
Setzen Sie zuerst den Parameter
P 01
( Betriebsart )
auf den gewünschten
Eingangsbereich bzw. Anzeigemodus.
5.1 Select the desired P 01 input range and
display mode by the mode register P01.
P 01
Bereich
Characteristic
Bild
Range
Characteristics
Figure
0 - 1 V
0 - 10 V
0 - 20 mA
4 - 20 mA
proportional
reciprocal
proportional
proportional
proportional
reciprocal
reciprocal
reciprocal
1
2
3
4
5
6
7
8
0 - 1 V
0 - 10 V
0 - 20 mA
4 - 20 mA
Bei eigener Festlegung des Messbereiches
durch externen Widerstand ist der Bereich
0 - 1V zu verwenden. Bei Pt100- Geräten
ist P01 irrelevant.
When you use an external resistor to make
your own range, select the 0 - 1 V mode.
With Pt100 version, P01 setting is not
relevant.
Bei proportionaler Betriebsart ergibt sich
die
Anzeige aus:
With proportional operation modes, the
unit
displays
Full scale
Input
( P 01 )
( V, mA )
Display
Scaling Factor ( P 02 )
Offset ( P 17 )
=
+
x
Bei reziproker Betriebsart ergibt sich die
Anzeige aus:
With reciprocal operation modes the unit
displays
Full scale
Input
( P 01 )
( V, mA )
Display
Scaling Factor ( P 02 )
Offset ( P 17 )
=
+
x
5.2
Setzen Sie den
Skalierunsfaktor P 02
auf
den Zahlenwert, den Sie bei Vollaussteuer-
ung anzeigen wollen
5.2 Set the scaling factor P 02 to the
desired display value at full scale input.