User Guide
IPico™ WN400 Integrated Access Device
User Guide © 2001 Lucid Voice
10
Placing a Call
To place a call, lift the handset, wait for a dial tone, and dial the leading
digits, followed by the port number (see Figure 4) of the extension that
you wish to reach. In Figure 4, to reach the extension on Port 0 attached
to the IP
ico
device on the left, lift the handset connected to either IP
ico
device and dial the leading digits (200), followed by the port number (0).
For example, to reach the extension on Port 3 attached to the IP
ico
unit
on the right, dial ‘3003’.
R e m o t e P B X C o n n e c t i o n
Setup
Figure 5
Connect Ports 0-3 of first IP
ico
unit to the outgoing lines (analog trunks)
of the PBX (left side in diagram), and connect analog telephones to Ports
0-3 of the second IP
ico
unit. You may also choose to connect handsets to
any unused ports on the IP
ico
that is connected to the PBX.
Note:
It is not necessary to attach a telephone or fax machine to
each port; you may use as many or as few as you wish.
