User Guide
IPico™ WN400 Integrated Access Device
User Guide © 2001 Lucid Voice
26
U s i n g C O M m a n d e r
1. HyperTerminal will not respond
• Try pressing <Enter> twice.
• Verify that you are using correct port settings as detailed in
Appendix A. Please refer to the
Changing the Master/Slave Setting
Using COMmander
section.
• The serial cable is not properly connected.
• Try using the alternative serial port on your IP
ico
device.
• The serial cable may not be a two-way crossover cable.
2. I cannot log in to COMmander
• Verify that you are using the COMmander password as your
password login (see Appendix A).
3. I encountered the following system error: ‘SIOCADDRT: Network is
unreachable’. What do I do ?
• You probably entered incorrect IP address settings. Verify that
IP
ico
’s LAN IP address is different from the WAN IP address.
IP
ico
’s default gateway IP address must either be on the LAN
subnet or the WAN subnet (usually on the WAN subnet).
U s i n g t h e W e b M a n a g e r
1. I cannot log in to the Web Manager from my browser application.
• Verify that your network settings are configured correctly. Please
refer to the next section,
Network Problems
.
• Verify that you are using the WEB password as your password
login
