IPico™ WN400 Integrated Access Device
User Guide
User Guide © 2001 Lucid Voice
7
Quick Installation
1. Pull power supply bracket until reaching ‘NC2’ mark.
2. Attach the power supply to the power supply bracket by firmly
inserting the metal latches into the appropriate slots in the power
supply bracket.
3. Place the IP
ico
unit onto the power supply bracket, positioning the
rear panel sideways from the power supply cable.
4. Connect the power supply cable to the power connection on the rear
panel of the IP
ico
and tighten the bolt.
5. Connect the power supply unit to the power connector.
6. Turn power supply switch to ‘ON’.
7. Turn on the IP
ico
unit by pushing the ON/OFF button on the back
panel. You will hear a beep. A green LED on the front panel indicates
that the power is ON.
8. Connect each IP
ico
’s WAN interface to a hub, using an Ethernet
cable. (You may also choose to connect the IP
ico
units to each other
using a crossover cable.)
9. Wait 60 seconds for a complete reboot.
10. Repeat these instructions to power up the second IP
ico
unit.
11. Pick up each telephone’s handset to verify a dial tone and put down
the handset.
12. See the
Placing Calls
section for further instructions.
