IPOne AirGate Wireless Series
5.4
Configuration Method
5.4.1
AP Set Up
Set up the AP, referring to the Guide. After connecting AP through the console cable and
executing hyper terminal, set its address, connect to web and then set ssid and
channels.
1. After connecting AP to PC with serial cable, execute Hyper Terminal.
2. Perform communication setting as below.
* Serial ports : Com1 or Com2
z
Bit/sec : 57600
z
Data bit : 8
z
Parity : None
z
Stop bit : 1
z
Flow control : None
3. Environment required for login is as follows:
z
Username :
ktroot
z
Password :
nespot
4. AP default is set according to KT
’
s environment. Items to be changed are as follows.
(Note: Do not change other than the following items).
z
IP address, Subnet mask, Gateway
- How to change IP , Subnet mask , Gateway
1) Basic commands in Console terminal (Hyper Terminal) are as follows:
P Status Information Check : S
DSL Status Information Check : A (AG2500)
P Setting : C
irmware Upgrade and other command : U
P reboot : reboot
gout : quit
2) If you want to change IP, Subnet mask and Gateway, log in and enter
‘
C
’
->
‘
I
’
in
order. Enter
‘
Y
’
if you are asked whether to change the setup, and go on according to
each step.
* A
* A
* A
* F
* A
* Lo
IPOne
www.IPOne.co.kr
40
