iPOWER TPD-800A User Manual
25
"RESTART" command line can be used to restart the system, the SSH interface will be closed automatically when
restart system, the IE browser interface and the TELNET interface will restart with the system.
11)
QUIT
"QUIT" to close the SSH system.
2.4.
TELNET command line console access
The application of Telnet provides the user with the ability of remotely login and controlling conveniently,
start the conversation by inputting the user name and password. Terminal user can input the command in the
telnet program to control and get better response,
The operation method of command line console is the same with SSH command line console, details please
refer to the SSH instruction.
3. Device Daisy-chain
The device support daisy-chain (see hardware user manual), user can monitor and control multiple devices at one
time conveniently, and 10 devices can be connected at most to one master, please see details as below:
3.1. Hardware setting
Firstly set up one Master and several Slaves, M/S indicator on is the Master while off is Slave, make sure the device
are connected in the right way.
Master setting: Press RESET button for 12 seconds (the interval of RUN light is 2 seconds), setting success when
M/S light on.
Slave setting: Press RESET button for 6 seconds (the interval of RUN light is 2 seconds), setting success when M/S
light off.
3.2. Software setting
There are three ways to set the daisy-chain by software, please details as below:
A. Log on to IE(Internet Explorer) browser access interface, open the "Device Configuration" and input the device
series number in the frame of TPD-800A Address No., check the setting success or not through reading the device
status of "Device Control" interface
B. Log on to SSH command line console access, command line of "Add Device" can be used to daisy-chain device
and add the corresponding device series, check the setting success or not through reading the device status of
"STATUS" interface
C. Log on to TELNET command line console access, command line of "Add Device" can be used to daisy-chain
devices and add corresponding device series number, check the setting success or not through reading the device
status of "STATUS" interface.
