8
8
To resume with the standard and primary motorized LED head rotations function mode. Re-press the mode push-
bottom in for 3 seconds and the LED head will rotate normally and illuminate activations between the 3 built-in PIR
motion sensor zones.
Audio mode setting:
For selecting which audio message will play when motion sensor detects
movement. Users can record their own sound to be played or select pre-recorded sound.
o
Pre-set default is “silent mode”
o
Push once for “doorbell chime”
o
Push again for “dog barking”
o
Push once more for the message you recorded (Message 1)
o
Push again for additional message you recorded (Message 2- you can record up to 2
messages at a time)
AUDIO MODE
SET/REC
PLAY/ERASE
MIC
The default setting is Mode 1. Under mode 1, if you want to select motor override function, press the mode push-
button located at the bottom of the fixture in for 3 seconds and a noticeable red LED light will flash rapidly through
the front PIR lens cover of the fixture that indicates this mode selection.
To switch Mode 1 to other 2 modes for the motor override function, press the mode push-button for 1 seocnd and
noticeable orange LED light or green LED light will flash rapidly through the front PIR lens cover of the fixture that
indicates this mode selection. (Note: repeat the same instructions if the working mode in the beginning is mode 2 or
mode 3)
On above selections the fixture LED head will be set in a fixed position. On motion sensor activations the LED light
source will come on and off with the LED head in a fixed or stationed position in the middle of the fixture.
