iQTS244
Operator’s Manual
888-274-7744
www.iqpowertools.com
En
gli
sh
Basic working techniques
MAKING THE FIRST CUT
While making the first cut you will notice the blade is
cutting into the plastic louvers. This is normal and part
of their design.
TYPICAL CUTTING OPERATION
The cutting head should be left in the lock down position
for typical tile cutting.
If the depth adjustment knob is used to set the depth of
the cutting blade above the table surface dust collection
will be limited.
MITER OR BEVEL CUTTING
(optional accessory)*
Attached the miter cutting guide to the rolling table for
miter or bevel cutting.
PLUNGE CUTTING
The cutting arm is spring loaded and adjustable up and down.
•Loosen the lock knob for the depth
adjustment. With the handle on the cutting
arm the cutting blade can adjusts up and down
and create a plunge cut in the work piece.
CUTTING LARGER FORMAT TILES
For cutting tiles or pieces in excess of 24 inches an
attachable table with integrated rip cutting fence* is
available. This accessory allows 48 inches length of cut.
WARNING!
INITIAL DUST COLLECTION
WILL BE LIMITED UNTIL THE
BLADE CUTS THROUGH THE TILE ENABLING DUST
CAPTURE DOWN INTO THE VACUUM SYSTEM.
OPERATING
WARNING!
OPERATING THE MACHINE
IN SITUATIONS WHERE DUST
COLLECTION IS LIMITED FOR PROLONGED PERIODS CAN
CREATE DUSTY AND POTENTIALLY HAZARDOUS WORK
ENVIRONMENT FOR THE OPERATOR AND OTHER PERSONS
IN THE VICINITY.
*Accessories can be purchased from your local iQ Power Tools dealer.
Call 888-274-7744 or visit www.iqpowertools.com to find a dealer near you.
Maintenance
GENERAL
To prevent accidental starting, the steps described
in this chapter must be performed with the motor off
and the power cable removed from the socket, if not
otherwise stated.
Wear personal protective equipment. See instructions
under the heading “Personal protective equipment”.
The life span of the machine can be reduced and the risk
of accidents can increase if machine maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest servicing dealer.
DAILY MAINTENANCE
• Check that the machine’s safety equipment is
undamaged. See instructions in the section
“Machine’s safety equipment”.
• Clean the outside of the machine. Do not
use a high pressure washer to clean the saw.
• Open the blade guard. Clean both the inside
and outside, and close the blade guard.
WARNING!
PLEASE READ THE OPERATOR’S
MANUAL CAREFULLY AND MAKE
SURE YOU UNDERSTAND THE INSTRUCTIONS BEFORE
USING THE MACHINE
NOTICE!
KEEP THE ROLLING TABLE
SURFACE FREE OF TILE CHIPS
AND
LARGE
DEBRIS.
WARNING!
NEVER CLEAN MOTOR AND
ELECTRIC PARTS WITH WATER.
NOTICE!
KEEP THE DUST COLLECTION
LOUVERS AND TOP SLOT FREE OF
TILE CHIPS AND LARGE DEBRIS.
CAUTION
FAILURE TO KEEP THE DUST
COLLECTION
LOUVERS
AND
TOP SLOT FREE OF TILE CHIPS AND LARGE DEBRIS COULD
RESULT IN THE ROLLING TABLE JAMMING AGAINST THE
TOP SLOT AND CAUSING DAMAGE TO THE MACHINE.
9.1
