2
3
5
6
1
4
Front
3. Output USB Ports
USB Ports:2PCS
4. 0utput : DC ports
DC Ports:4pcs
Size:
Φ
2.1×6
Output: 12VDC 3A / SET
AC adapter
Car adapter
5.
ON/OFF
The switch without control
the AC
6.
Charger In
（
Solar In) ,1pc
Size:
Φ
2.5×6
Charger In: solar panel
1. Charging and fault lighting
Red-Lighting: charging
Red-Lighting: flash
SOLAR CHARGE
OUTPUT
USB DC 5V
OUTPUT
DC 12V
OUTPUT
DC 12V
OUTPUT
DC 12V
OUTPUT
DC 12V
OUTPUT
USB DC 5V
Battery level LED indicator
Starting up
Check that the power pack switches are in the “ON” position
before charging in.
Recovery voltage
Charging step – By Solar Panel
SOLAR CHARGE
Charging in
Flash - The battery power is low
Check that the power pack switches are in the “ON” position,
locate the solar panel in direct sun light up to the DC input .
SOLAR CHARGE
Indicates that the system will trigger the low battery Protection,
Charging to the recovery voltage , the system can start,
Charging to the recovery voltage 12 VDC.
Red-Lighting: charging
Check that the power pack switches are in the “ON” position.
Charge light will turn on while charging
Once charging completed, four Green lights will stop flashing.
Charging AC Adapter 110V
SOLAR CHARGE
Red-Lighting: charging
Charging in that the four instructions without rules of flash.
DC OUTPUT
Support USB charging or load
to use.
Mobile phone charging
USB*2 parallel output:
5 VDC / 1.6 A
General USB output,
Support USB charging or load use.
DC jack * 4pcs (5.5*2.1) output:12 VDC,
Single-port maximum output 12 VDC / 3A (36W)
General use as lighting and etc DC.
Includes overload and reverse polarity protection
connect using the extension leads of Cigarette Lighter
Adapter and turn on via the inline switch to each light.
AC Inverter output
Inverter unit runs a loss, when not in use,
please turn the main switch off.
SMART AC inverter output as independent system;
Please pay attention to the power AC load, no more
than inverter capacity 200W.
The iQ2 360W has a built-in intelligent temperature controlled
fan that cools the inverter and will automatically start at 45 C.
Overload and short circuit protection
SOLAR CHARGE
OUTPUT
USB DC 5V
OUTPUT
DC 12V
OUTPUT
DC 12V
OUTPUT
DC 12V
OUTPUT
DC 12V
OUTPUT
USB DC 5V
Red flash -
Includes overload and etc protection.
Please turn off the power switch & Disconnect the load and
then restart.
Includes overload and etc protection.
Please turn off the inverter of power switch & disconnect the
load and then restart.
2. Battery Charge Level
Green lighting
SOLAR CHARGE
!
Operation
●
Operation
●
Variants
●
Push
!
Rear
7
8
9
7.
AC ON / OFF
8.
AC output, 1pc
9.
AC output indicator light
5VDC 0.6A
5VDC 1A
The iQ2 360W Solar Power Pack is equipped with several built-in safety
features. In the event your battery has been fully depleted, and or the
unit is not taking a charge (RED charge light indicator will be on while
charging) you will need to follow the following charging instructions
below in order to reset the Battery Discharge Safety:
* Make sure unit power is "ON" while charging.
* Pull charging cord plug, either solar or AC charging, doesn't matter,
out of the charging port.
* Insert the charge cord plug into the #4 DC Output port. IMPORTANT
NOTE: Both the RED charge light indicator and GREEN light charge
gauge will light up immediately...REMOVE the charge cord plug from the
DC port.
* Re-insert charging cord plug into the charging port. The unit will
continue charging.
* Once the unit is charging the indicator lights will beg
in
to flash.
The AC adapter box will get warm during charging.
SPECIAL NOTE
: For maximum battery performance and longevity, it is
recommended that you do not fully deplete the battery. Keep the battery
charged above 25%.
