GW-WIFI-01
User_Guide_GW -WIFI-01_180511
Page 31
First startup
Factory settings
GW-WIFI-01 is set from the factory as follows:
WiFi mode
Access point
SSID name
„IQRF-xxxx“
, where
xxxx
are last 4 digits of the MAC address.
Security type
Open
User name
“iqrf”
Password
“iqrf”
Operation mode
Datalogger
IQRF Cloud
Enabled
IQRF Cloud hosting
By CIS (
Communication period
10 s
To enable IQRF Cloud services, the WiFi network must be configured at GW-WIFI-01 allowing Internet access and then
optionally an access to Cloud server. This can be accomplished by IQRF IDE via USB interface or via internal web interface.
For more information refer to chapters
WLAN
(for IQRF IDE) or
WiFi setup
(for web server) above.
When WiFi network is configured and GW establishes Internet connection, this setting can be used to operate the GW with
IQRF Cloud without any changes in configuration. But it is strictly recommended to change the GW password to avoid illegal
access to GW data.
Step by step guide
To get familiar with GW-WIFI-01 functionality, the GW can be used with DPA hardware profile in similar way as which is
described in IQRF DPA Quick Start Guide:
Follow this Guide, chapters 1 to 5.
Use GW-WIFI-01 instead of CK-USB-04(A)
GW-WIFI-01 is delivered with the
(General)HWP-Coordinator-STD-SPI
plug-in uploaded in internal TR transceiver.
Thus, there is no need to upload any HWP plug-in.
After LED control testing from IQRF IDE via USB according to chapter 5 mentioned above, test the same commands via
Ethernet:
Disconnect the GW from IQRF IDE.