VCP-QVGA-02
UART interface
Digital pins to connect serial UART hardware module inside the MCU are available on the system connector. To connect
standards like RS-232 or RS-485 proper circuitry must be used on the user equipment.
Temperature sensor
Temperature can be measured by sensor MCP9802 with I2C interface. This IC is not assembled in standard delivery.
External I2C device
Any device with I2C interface can be connected externally.
Tilt sensor
3-axis linear accelerometer LIS344AL is connected to the corresponding analog inputs. It is intended as a tilt sensor to
support portrait
/
landscape view switching by SW.
TR module
IQRF wireless transceiver module in SIM card format, e.g. TR-52B is supported. It is delivered on request only. The SIM
connector is always included.
Connectors
connector
pins
type
System
40
FX2-40P-1.27SVL (Hirose). Mating type: FX2-40S-1.27SVL (Hirose).
TR module
8 + 1
SIM con through hole soldering for possible mechanical fixation
SD card
8
DM3AT-SF-PEJ (Hirose)
I2C
5
Cable connector
Programming and debugging
Refer to the DS-QVGA-02 development set.
Software
Refer to the DS-QVGA-02 development set.
© 2011 MICRORISC s.r.o.
www.iqrf.org
MNVCPQVGA02_110810
Page 4
