©2016 IQtronic technologies Europe, s.r.o.
Page 17 of 22
Syntax is : -20.3:5.5 or 10.5:35.0 , where the first temperature before the
colon is the temperature EXT (external temperature, based on which is then
maintaining the temperature INT) after the colon is the temperature of the
internal (INT) - maintained in the given area.
Temperatures outside of inserted points are calculated by linear extrapolation.
Values above the maximum or below the minimum are extrapolated.
Deletion we will perform by inserting the text "ALL" and pressing the Delete
key or by a text containing a row for deletion.
4
Use of the button DEF
By briefly pressing a button on the the board we switch the output relay. If the
button is held down for more than 4 seconds and then released, all LEDs will
start flashing for 10 seconds. In case of further pressing during the blinking,
the device will reset to factory settings
.
5
Software
5.1 Utility IQlocator.exe
The program is used to quickly locate the device on a network, change its IP
address and to upload new software updates - upload firmware.
The connected device is found after running the programs and pressing the
SCAN button.
Note:
The device shown warning in status red line in case of wrong user
input .
