©2016 IQtronic technologies Europe, s.r.o.
Page 7 of 22
3
Device configuration
- Connect the connecting cable to the computer via an RJ45 connector to the device.
- Set up the following on a PC network card, to which the device is connected:
192.168.0.11, mask 255.255.255.0
-Optionally run IQlocator.exe application that locates the device and it is possible to
change the address directly in the device, see. Chapter 9.
- The default IP address of the device is 192.168.0.100.
- Start the Web browser with a default ip:
- In case of using an alias NetBIOS name - IQTB-TC840
3.1 Displaying current values.
The page will display all data; the current state of the outputs; both of
temperature sensors; device temperature; their extreme values; current time
obtained from the NTP; status of change counters of outputs. All these values
can be read using SNMP protocol version 1.0 or possibly adjust the output
relay
.
It is also possible to set sending TRAP packet in case of exceeding one or
more of the conditions.
Values can be read and reset via SNMP. You can also read the stored values
from the data logger.
