11th Guiyang Street, YEDA,
Yantai 264006, P.R. China
+86-400-998-3088
Laser cursor
calibration
If the actual location differs from the location marked by the laser pointer,
you can use this function to calibrate the laser pointer.
z
Press and hold the
Menu button (7)
to go to the main menu interface.
z
Short press the
Up/Zoom button (6)
or
Down/Photo button (8)
to select
the Laser Pointer Calibrate option.
z
Short press the
Menu button (7)
to enter Laser Pointer Calibrate options.
The laser indicator is enabled automatically.
z
The laser pointer appears in the middle of the screen and the prompts
shown in the following figure are displayed in the upper left corner.
-
X indicates the X-axis in the horizontal direction
-
Y indicates the Y-axis in the vertical direction
-
Center means to return the cursor to the center of the screen.
-
Default means to return the cursor to the factory default.
z
Select the options with the
Up (6)/Down (8)
button, and confirm your
selection with a short press of the
Menu button (7)
.
z
When the
X
or
Y
is selected, the icon will become blue and continuously
flashing. Then, move the cursor with a short or long press the
Up
(6)/Down (8)
button. Press the
Up button (6)
to move the cursor right or
up and the
Down button (8)
to move left or down. Short press to move
one pixel every time and long press to move ten pixels once.
z
When cursor moved to right position, briefly press the
Menu button (7)
to save the position, and the icon will stop blinking.
z
Switch to another axis and repeat until the cursor is aligned with the
