QPSK/IP DEMODULATOR
CI Source:
press the
<ENTER>-key
, then use < > or < >-key select Tuner or ASI input or
TS/IP input (only when the TS/IP is set
“IP In”, refer section 7.4.6 for details) to set the signal
source of descrambling, press
<ENTER>-key
to save or press
<EXIT>-key
to scrap.
Setup:
under this sub menu, you can see all program names from the source of CI that was
set in
‘CI Source’ previously. All free programs are marked with
‘Free’
in the first row.
To select which program to be de-encrypted, press the < > or < >-key to roll up and down
the program names and press
<ENTER>-key
to change the status of the corresponding
program (only encrypted program could be selected). Three different statuses could be set:
Slot 1 (de-encrypted with upper CAM inserted)
Slot 2 (de-encrypted with lower CAM inserted)
Bypass (no de-encryption).
The status will be shown in the first row on the LCD display. Confirm this setup when leaving
this sub menu, press
<ENTER>-key
to save or press
<EXIT>-key
to scrap.
The de-encrypted program could be delivered to other functional blocks, like A/V decoder,
ASI, ASI2/SDI, Mux/Filter and TS/IP output (refer to section 7.3.3~7.3.6 for more).
7.3.3 Ethernet
You can configure the parameters of Video and Audio of the program decoded by AV decoder.
Program:
under this sub menu, you will see all program names detected by this equipment-x.
The programs could be coming from ASI input, Tuner, TS/IP input or the internal CI de-
encryption block. Use the < > or < >-key to roll up or down between the program names,
and use < >-and < >-key to switch among input sources, where a number in front of the
program name indicates the input source:
0-xxxxx
displays the program name, which comes from ASI input.
1-xxxxx
displays the program name, which comes from TUNER input.
2-xxxxx
displays the program name, which comes from TS/IP input
3-xxxxx
displays the program name which comes from the CI.
A few seconds after the program being selected, the A/V signal will be delivered to the related
connectors on the back panel.
Video:
You can configure the video parameters of programs in this submenu. Press the
<ENTER>-key to confirm or press the
<EXIT>-key
to cancel.
Video Standard: you can select Auto or SECAM or NTSC or PAL for the composite video
output.
Screen:
select the screen mode: 4:3 Full, 16:9 Full or 4:3 Letterbox.
DVB Subtitle Lang:
select the language of DVB Subtitle.
EBU Subtitle Lang:
select the language of EBU Subtitle.
Subtitle Priority: configure the priority of Subtitle; choose whether DVB or EBU should be first.
Audio:
You can configure the audio settings in the submenu.
Audio Level: use the < > < > < > < >-keys to modify the audio level within this range: 0~99.
Audio Mode: select Stereo, Left, Right or Mono for soundtracks.
Audio Language: select the language of the audio.
7.3.4 ASI
You can configure the settings of ASI in this menu.
13
