( Figure 3)
( Figure 4)
Screw the screws in to the hole which got in step 1 and tighten it, take care the
direction, should be screw it from right to left. (Figure 3)
Prepare the cylindrical fixed pipe.(Figure 4)
Put the cylindrical fixed pipe in to the hole on the right armrest, take care that the
sthere hole on the fixed pipe should be one to one corresponded with the hole on
the arm rest of the flange plate. (figure 5)
Screw three screws to tighten it ( figure 6)
( Figure 5)
( Figure 6)
Note: the gap should be
face down and vertical to the earth
Prepare the handle controller frame assembly in step 3.(figure 7)
Insert the handle controller frame assembly in to the cylindrical fixed pipe, be carefully
that the two groups hole out side and inside should be one to one correspond.(figure8)
( Figure 7)
( Figure 8)
Prepare two screws which tighten on two sides (figure 9)
Screw the two screws on two sides make it tighten, finish the installation( figure 10)
( Figure 9)
( Figure 10)
8.Controller installation and usage
Insert the handle controller in to the frame (figure 1), the frame can turn left and rig ht
freely(Figure 2).and the handle controller can swing freely in horizontal
direction(Figure 3).
( Figure 1)
( Figure 2)
( Figure 3)
ENLARGE
FIGURE
Method of usage
Method of usage
16
17
