14
15
Figure
Figure
Figure
Figure
8
Figure6
Figure7
Method of usage
Method of usage
Gently hold the armrest side.When revolve the shaft, firstly put into cage ring,
then put into big washer and wrest the locknut by specialized tools. (Figure 6).
Thread the socket head cap screws into upper tightening cap (Figure 7), then
use the provided wrench to screw in upper supporting gear and wrest screw
tight.
Thread the socket head cap screws into lower tightening cap (Figure 7), then
use the provided wrench to screw in lower supporting gear and wrest screw
tight.
Respectively connect air pipe and valve connector with relavent connectors on
the iron plate of armrest (Figure 8).
Check if the armrest is well fixed. If there isn't much swing, close the big and
small cover outside the armrest. (Figure 9).
Close the zipper of lower armrest and finish installation.
Be careful don't put stress on the
two sides of armrest in order to
support the body (Figure10)
Be careful don't put stress inwardly
on upper arm airbag support board
(Figure 11)
Enlarge sketch map
7.Handle controller frame installation
Handle
controller tray
Screw
Frame
Handle controller
frame assembly
Ready for the handle controller tray, steel pole, take out the fixed screws on the
handle controller tray. (Figure 1)
Insert the ball joint of the steel pole to the concave spherical of the handle controller
tray.(figure 2)
( Figure 1)
( Figure 2)
1.Distance sleeve
2.Big washer
3.Lock nut
