Connect the joint of air pipe and power cord (note: there's marks on the air pipe and
size of cable connectors is different, you won't miss it). (figure 9)
Pull the calf rest air pipe and power cord through the hole of front dam-board, then
tighten the screws of dam-board. (figure 10)
Figure 9
Figure 10
Zip the backrest kneading cloth up.
figure 11
Plug the heat plug of the back cushion into the heat hole on the backrest, put the
back cushion tidily on the backrest. (figure 12)
Figure 11
Figure 12
The calf rest decoration cover is card slot design, make an effort to push it when
assembly (note: please keep the cover tight with the side), armrest installation is
completed. (figure 13)
Push
Figure 13
6.Calf installation
Install the rotating shaft incalf fixed axis first, noticed the hole should be aligned, so
that the R shape pin assembly (chart 1)
After calf is connected with the fixed axis aligned, then insert (chart 2)
chart 1
chart 2
Plug R pin, then moved to the other side of the calf, and the plug R pin (chart 3)
Finished (chart 4)
chart3
chart4
When the machine under the working state, with lying and calf rest lifting, you
could not apply gravity on the calf, to prevent the massage chair does harm to
peoplebefore dumping(chart1).
chart2).
Ensure the mechanism hands not in the seat part ,otherwise will cause
uncomfortable in the Buttock when you seating in the chair(
Note
chart1
chart2
Method of usage
Method of usage
15
14
