6. Checkup
1)
Make sure to apply Lubricant where needed and check for loosen nuts
and bolts before operating.
2)
Check for air pressure on the tires.
3)
Test drive the equipment before actual use.
7. Storage
1)
When the equipment is to be stored for a long time, apply lubricants
to the area where it is likely to have corrosion.
2)
Firmly secure the fertilizer spreader on the flat surface to prevent any
possible fall off.
3)
Keep it away from children to prevent any safety hazard.
4)
When the equipment is to be stored for a long time, store it in indoor.
If it is to be stored outside, place it on the flat surface and cover it
with protectors to prevent any source of damages from rain and snow.
- 6 -
Summary of Contents for IPS-200
