IPU 40060 Issue 9
Page 3 of 27
1
Getting Started
This User Manual refers to the IRISYS Universal Thermal Imager system type IRI
1011, for use with a ‘Pocket PC’, Palm or a PC.
1.1
Unpacking
After unpacking the IRI 1011 toolbox, you will find the standard items as shown in
Figure 1
.
Figure 1: Contents of the IRI 1011 Universal Thermal Imager
Inspect all the items. If any item is damaged or missing, notify your dealer
immediately.
1.2
Powering the IRI 1011
The IRI 1011 Thermal Imager operates from either 4 standard AA size batteries, or
from AC mains power.
1.2.1
Using Battery Power
1.
Make sure the Thermal Imager is turned off.
Figure 4,
shows where the on/off
button is.
2.
Open up the battery compartment on the bottom of the IRI 1011 Thermal
Imager, by sliding the battery cover off.
3.
Carefully remove the battery holder and insert 4 AA size batteries. Standard
AA Alkaline batteries or rechargeable batteries can be used. The polarity of the
batteries is shown on the holder.
4.
Replace the battery holder, making sure that the connector is positioned so that
it is towards the centre of the imager, and replace the battery cover.
CAUTION: Do not use a 9V battery.
Figure 2: Inserting 4 AA Size Batteries into the IRI 1011
RS232
Connection
Cable for a
PC
Regional
Mains
Adapters
12V Power
Supply
Toolbox Carry
Case
Battery
Holder With
4 AA Size
Batteries
CD-Rom
IRI 1011
Thermal
Imager
Battery
Compartme
Battery
Cover
Empty Battery
Holder
Battery Holder
with 4 AA size
batteries
