IPU 40060 Issue 9
Page 7 of 27
2.3.1.2
Starting the IRISYS 1011 Imager software
1.
Check that the ‘Pocket PC’ is charged.
2.
Make sure the ‘Pocket PC’ is connected to the IRI 1011 Thermal Imager with an
RS232 serial sync cable. The serial sync cable is either supplied with the
‘Pocket PC’ as a standard item or can be ordered from the ‘Pocket PC’ supplier
as an accessory.
3.
Switch on the ‘Pocket PC’ and the Thermal Imager.
4.
Using the Stylus pen from the ‘Pocket PC’, select the
Start
menu and then
select the
Programs
folder. Select the icon labelled
“
IRISYS 1000+
Imager”
.
5.
Operation of the IRISYS 1011 Imager application is by means of the
Navigation/Action button and software buttons. See Sections
2.3.2.2
for
further information.
NOTE:
•
The IRISYS Imager program takes a few seconds to load.
•
If the ‘Pocket PC’ battery is allowed to fully discharge, the imager software will be lost and
must be re-installed either from memory storage or from the CD again. The ‘Pocket PC’
uses power even when it is switched off. Regular recharging and transferral of images is
therefore recommended.
2.3.1.3
Reinstalling the IRISYS 1011 Imager software onto a ‘Pocket PC’ from
Flash Memory.
2.3.2
Operating the ‘Pocket PC’ with the IRI 1011 Thermal
Imager
Figure 5: Screenshot of IRISYS 1011 Imager ‘Pocket PC’ Software
Pocket PC Battery
Indicator
Selected
Temperature
Range
Temperature
Range
Temperature
difference
between the
two selected
temperature
cursors
Temperature
cursor and
corresponding
temperature
reading
Default
Laser
Pixel
The imager software can be re-installed from flash
memory storage on newer Pocket PC’s using File
Explorer. For example on HP iPAQs, open “File
Explorer”, first select “My Device” from the drop down
menu at the top of the screen, then select “iPAQ File
Store” and finally “1000 Series Imager”. Select “OK” to
confirm re-installation.
