8
For more information, visit global.irobot.com
EN
FCC Supplier’s Declaration of Conformity
iRobot Corporation Roomba Model: RVE-Y1
Contains FCC ID: UFE-AXGY1 and contains IC: 6652A-AXGY1
This device complies with part 15 of the FCC Rules and ICES-003.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
• Changes or modifications not expressly approved by iRobot
Corporation could void the user’s authority to operate the equipment.
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules
as well as ICES-003 Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
to radio communication will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
• Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than the necessary for successful
communication.
• FCC Radiation Exposure Statement: This product complies with
FCC §2.1091(b) for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as
described in this manual. Per FCC requirements, maintain a distance
of more than 8 inches (20 cm) between any person and the host
device (Roomba robot).
• ISED Radiation Exposure Statement: This product complies with the
Canadian Standard RSS-102 for mobile device RF exposure limits,
set forth for an uncontrolled environment and is safe for the intended
operation as described in this manual. Per ISED requirements,
maintain a distance of more than 8 inches (20 cm) between any
person and the robot.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA.
http://global.irobot.com
For battery recycling go to call2recycle.org;
or call 1-800-822-8837
Regulatory Information
