Before Each Use – Work Site Selection & Set-Up
17
Step Three: Work site selection and log splitter set-up
WARNING
It is important to select an appropriate work site and properly set up the log splitter in order to minimize the risk of
slips and falls, equipment rolling or tipping over, carbon monoxide poisoning, and accidental fires.
1. Select location
Select an appropriate location for operating the log splitter.
Requirements:
1. Dry, level surface with good footing. Stay clear of areas with mud, ice, tall grass,
weeds, or brush.
2. Outdoors, away from air intakes.
DANGER
: The running engine gives off carbon monoxide, a poisonous gas that can
kill you. You CANNOT smell it, see it, or taste it.
ONLY run log splitter OUTDOORS and at least 20 feet from the home, away
from windows, vents and air intakes, to allow proper ventilation. NEVER run log
splitter inside homes, garages, sheds, or other buildings or semi-enclosed spaces.
These spaces can trap poisonous gases, EVEN if you run a fan or open windows.
If you start to feel sick, dizzy, or weak while using the log splitter, shut off the
engine and get to fresh air RIGHT AWAY. See a doctor. You may have carbon
monoxide poisoning.
2. Fire precautions
Take the following precautions against fire:
1.
IMPORTANT: If your splitter will be used near any unimproved forest, brush,
or grassy covered land,
then engine must be equipped with a spark arrestor.
2.
Make sure you comply with applicable local, state and federal codes.
3.
Keep a fire extinguisher available (classified for both ordinary combustibles &
flammable liquids) as a precautionary measure when operating the log splitter in dry
areas.
3. Position 7’ from
any combustibles
or flammable
liquids
Position splitter at least 7 ft. from combustible objects during operation.
Hot exhaust fumes from splitter engine could cause fire. Also, hydraulic oil leaking or
spraying on hot engine can ignite.
4. Block Wheels
Block wheels to prevent unintended movement of the log splitter.
Summary of Contents for BH2W2016GX
