Initial Set-up
8
WARNING
Carefully read and follow all instructions for initial assembly and set-up of
this log splitter.
Failure to properly assemble and set up this equipment could result in serious
injury to the user or bystanders, or cause equipment damage.
Step One:
Assemble log splitter
Assemble your log splitter.
See the “Assembly” section of this manual – It will provide you with detailed instructions
on:
Inspecting shipped components and whom to contact if anything is missing or
damaged.
Assembly.
Testing.
Step Two:
Add oil to engine
Add oil to engine.
Using a funnel, add SAE 10W-30 oil up to the FULL mark on the dipstick. (See
engine Owner’s Manual for oil capacity and location of fill cap.)
Step Three:
Add Hydraulic Oil to
Reservoir
1.
Remove hydraulic oil dipstick.
2.
Refer to the
Specifications
section for approximate hydraulic oil capacity.
3.
Fill reservoir with 10 wt AW32, ASLE H-150, or ISO 32 oil. Use a funnel
4.
Replace hydraulic oil dipstick and check that oil level reads full. Note: Do not
thread in dipstick when checking oil level.
5.
Disconnect the spark plug wire from the spark plug
6.
Pull on the starter grip recoil at least 20 times so that hydraulic fluid has cycled
through the pump
7.
Reconnect the spark plug wire to the spark plug
8.
Start engine and use split control lever to extend and retract wedge 5 (five) times
to remove air from the high pressure lines.
9.
With wedge retracted, check oil level again. Fill if necessary.
Note:
If the log splitter will be run for long periods of time in outdoor temperatures above
70
F, we recommend changing the hydraulic oil to DEXTRON III.
Oil dipstick
Hydraulic oil
Summary of Contents for BH2W2016GX
