46
Assembly Instructions
Tools Needed
•
10mm Deep Well
Socket
•
Ratchet
•
Torque Wrench
•
Side Cutter
Step 8 –Low Pressure Return Hose
•
Place two hose clamps on the low pressure return hose.
•
Route the low pressure return hose from return filter fitting to valve
outlet fitting around tow bar as shown.
•
Position and tighten hose clamps approximately 3/8” from ends of
hose.
Torque hose clamps to 35 in.-lbs.
•
Unlatch vertical latch and rotate splitter beam to the horizontal
position. Check all hoses for kinking or rubbing on sharp metal edges.
Loosen, twist, and retighten if necessary. Return to vertical position.
•
Once the hoses are placed correctly and do not kink or rub going to
and from the horizontal position, wrap zip ties around both hoses as
shown below and tighten. Cut off tail end of zip ties with side cutter.
Fasteners Needed from Parts Bag:
Part # 82157
Zip Tie
Qty: 3
Part # 797945
1-1/8 to 1-1/4 T-Bolt Hose Clamp
Qty: 2
Valve Outlet
Fitting
Return Filter
Fitting
Zip Tie
Zip Ties
