10
The main cutting height adjustment is achieved by using the screw jack, to raise or lower the
cutting deck as necessary.
CUTTING HEIGHT ADJUSTMENT:
Turn the handle to raise or lower as necessary.
READ AND UNDERSTAND THE ENGINE OPERATORS MANUAL BEFORE USE
Observe all safety precautions; keep hands and feet away from rotor and other
moving parts. Keep spectators at a safe distance.
1
Make sure there is a gap between the blades and the ground / crop.
2
Select an area clear of loose debris that could be picked up.
3
Set the engine choke, and suitable idling speed with the throttle.
4
Place one foot on top of the deck body to give a firm and balanced position. Pull the
starter cord firmly, allowing the cord to return to return to the housing slowly (one or
two strong pulls should start the engine).
5
After a few seconds warming up at idling speed, move the throttle to the factory pre-set
working position to give a normal/working engine R.P.M of 3600 max.
5.3 MOWER CUTTING HEIGHT
5.4 STARTING THE ENGINE
NOTE If the throttle is altered to increase the engine R.P.M beyond the
recommended level, the guarantee may become invalid. In addition to this, cutting
efficiency will be reduced, fuel consumption will increase and excessive vibration
could be caused, resulting in a potential danger to personnel and damage to
components.
