Matrix III MF-I
Mifare 13.56 MHz RFID reader
with connection via iButton / Wiegand-26 protocols
User Manual
1. OVERVIEW
Matrix
III MF-I reader is used in Access Control Systems (ACS) to acquire codes from approached
Mifare tokens (cards, key fobs, bracelets etc.) and transmit them to controllers via iButton (Dallas
Touch Memory) or Wiegand protocols.
A distinctive feature of this model is the support of IronLogic Protected technology, which provides
reliable protection against card cloning (more details on www.ironlogic.
me
website
)
. To use
Protected technology, in addition to a Matrix
III MF-I reader, customers require: a Z-2 USB MF
reader with special firmware, an IronLogic Object Card and clean Mifare cards or key fobs to create
access cards.
2. SPECIFICATIONS
- Working frequency:
.
..........
...................................................................................
13.56 MHz;
- Supported tokens type:
.............
Mifare Ultralight, Mifare Standard (Classic) 1K, 4К, Mifare ID
;
- Card/key fobs reading distance:
................................................................................
2
…6 cm;
- Output protocols:
....................................................
iButton (Dallas Touch Memory), Wiegand;
- Line distance from controller:
using iButton (Dallas Touch Memory) protocol:
.......................................................
up to 15 m;
using Wiegand protocol:
.......................................................................................
up to 100 m;
- Card reading status indication:
...........................................................
buzzer, bicoloured LED;
- Indication control:
........................................................................................
internal / external;
- Power
supply
voltage:
................................................................................................
12 V DC;
- Current in Card Standby mode:
.............................................................................
up to 40 mA;
- Dimensions:
..................................................................................................
118 x 45 x
22
mm.
3. MOUNTING AND CONNECTION
The reader should be mounted on a flat surface, in a place allowing unimpeded token access to the
reader.
To mount the Matrix
III MF-Ireader, perform the following operations:
1. Mark and drill the mounting holes (Fig. 2)
2. Connect the reader wires, as per Table 1.
3. Insulate the wire junction points.
4. Supply power to the device (the LED shines red).
5. Test proper device operation by approaching it with a token.
6. Mount the reader in the desired place and fix it with the supplied screws.
7. Snap on the decorative case and fix it with the supplied screw.
Note 1:When install two readers closer than 10 cm from one another, connect the SYNC wires
(orange) on both readers to each other.
Note
2: Mount the device under ambient temperature no colder than −5°C.
Note
3:To ensure proper operation at the specified distance between reader and controller, a
CAT5e UTP cable must be used (see Fig.1).
page 1
MATRIX III MF-I
www.ironlogic.
me
