4.3. Add Master Cards (1m, 1M)
Touch the reader with a Master card (short touch). On touch, the controller issues a short beep
acknowledging the Master card; then within 6 s touch and hold the Master card at the reader
(long touch). On touch, the reader issues two short beeps denoting the second Master card
touch in programming mode, and in 6 s, a beep acknowledging Add Master Cards mode. Now
remove the Master card from the reader.
To add more Master cards, keep touching the reader with them one after another, with intervals
between touches ≤16 s. Each new card touch is acknowledged by the reader with a short beep.
If a card is already stored in memory as a Master card, no signals are issued. Exit from this
mode happens automatically, in 16 s after the last touch. The reader confirms exit with a series
of five short beeps.
4.4. Erase Normal Cards with a Master Card (2m, 1M)
Touch the reader with a Master card twice (short touches). On first touch, the reader issues a
short beep acknowledging the Master card. On second touch, the reader issues two short
beeps, denoting the second Master card touch in programming mode;then within 6 s touch and
hold the Master card at the reader (long touch). On third touch, the reader issues three short
beeps, and in 6 s, a beep indicating transition to Erase Normal Cards mode. Now remove the
Master card from the reader.
To erase cards, touch the reader with them one after another, with intervals between touches ≤
16 s. Each card touch is acknowledged with a short beep. If the card was not present in
memory, two short beeps sound. Exit from this mode happens either automatically, in 16 s after
the last touch, or after a Master card touch. The reader confirms the exit with a series of five
short beeps.
4.5. Erase All Memory (3m, 1M)
Touch the reader with a Master card three times (short touches). On first touch, the reader
issues a short beep acknowledging the Master card. On second touch, the reader issues two
short beeps, denoting the second Master card touch in programming mode. On third touch, the
reader issues three short beeps, denoting the third Master card touch, and within 6 s touch and
hold the Master card at the reader (long touch). On fourth touch, the reader issues four short
beeps, and in 6 s, another series of short beeps, indicating the erasure of entire reader memory
and exit from the programming mode. Now remove the Master card from the reader; the
Programming mode will be automatically re-entered after next power-up.
Note: When erasing the whole database using a Master card, the programmed Door Release
Time is NOT reset.
4.6. Programming Door Release Time (4m)
Touch the reader with a Master card four times. On each touch, the controller issues beeps
acknowledging the Master card touches, their number corresponding the number of touch. So
on fourth touch, the controller issues four beeps and enters the Door Release Time
Programming mode. Within 6 s after the last touch, turn down the internal lock handle and hold
it for the exact time you want to set as door release time. During door release time programming
the blue LED will keep flashing. When the lock handle is released, the controller issues a beep
and stores the measured time into its memory.
page 7
Z-8 EHT
www.ironlogic.
me