Kwik-Way
SVS II Deluxe Valve Refacer
Copyright © 2018 by Irontite Products Inc.
All Rights Reserved. Rev. 180802
pg. 6
SAFETY INSTRUCTIONS
1. Read, understand and follow the safety and operating instructions found in this manual. Know the
limitations and hazards associated with operating the machine.
2. Eye Safety: Wear an approved safety face shield, goggles or safety glasses to protect eyes when
operating the machine.
3. Grounding the Machine: Machines equipped with three prong grounding plugs are so equipped for
your protection against shock hazards and should be plugged directly into a properly grounded three-
prong receptacle in accordance with national electrical codes and local codes and ordinances. A
grounding adapter may be used. If one is used, the green lead should be securely connected to a
suitable electrical ground such as a ground wire system. Do not cut off the grounding prong or use
an adapter with the grounding prong removed.
4. Work Area: Keep the floor around the machine clean and free of tools, tooling, stock scrap and other
foreign material and oil, grease or coolant to minimize the danger of tripping or slipping. The
Company recommends the use of anti-skid floor strips on the floor area where the operator normally
stands and that each machine's work area be marked off. Make certain the work area is well lighted
and ventilated. Provide for adequate workspace around the machine.
5. Guards: Keep all machine guards in place at all times when machine is in use.
6. Do Not Overreach: Maintain a balanced stance and keep your body under control at all times.
7. Hand Safety: NEVER wear gloves while operating this machine.
8. Machine Capacity: Do not attempt to use the machine beyond its stated capacity or operations. This
type of use will reduce the productive life of the machine and could cause the breakage of parts,
which could result in personal injury.
9. Avoid Accidental Starting: Make certain the main switch is in the OFF position before connecting
power to the machine.
10. Careless Acts: Give the work you are doing your undivided attention. Looking around, carrying on a
conversation and horseplay are careless acts that can result in serious injury.
11. Job Completion: If the operation is complete, the machine should be emptied and the work area
cleaned.
12. Disconnect All Power and Air to Machine before performing any service or maintenance.
13. Replacement Parts: Use only Kwik-Way replacement parts and accessories (manufactured by Irontite
Products Inc.); otherwise, warranty will be null and void.
14. Misuse: Do not use the machine for other than its intended use. If used for other purposes, the
Company disclaims any real or implied warranty and holds itself harmless for any injury or loss that
may result from such use.
