Page of 21
9
1. Position the water reservoir tray below the
sharpening wheel, with the support hooks of the
tray facing the side of the housing. Lift the tray
until the support hooks sit in the corresponding
slots in the housing. Check that the tray is
horizontal and steady.
2. A water level indicator line shows how high
the water reservoir tray should be filled with
water.
Note: The first time the sharpener reservoir is
filled with water, the sharpening stone may
absorb some of the water, regularly monitor and
fill reservoir as required.
3. To remove the water reservoir tray, disengage
the support hooks from their corresponding slots
by lifting and moving the tray away from the side
of the housing. When the hooks are clear, lower
the tray.
Note. After use, the water reservoir tray should
be emptied of water and cleared of any debris
that remain from the sharpening process.
Setting up for sharpening
When sharpening, position the tool support bar in the top mounting holes.
Note. Sharpening is performed against the direction of rotation.
1. Fit the adjustable tool holder to the tool
support bar (See “Installing the tool holder”
section). Loosen the tool support clamps. Adjust
the height of the tool support until there is a
small gap between the surface of the sharpening
wheel and the lower guides of the adjustable tool
holder.
