Ironwood BR23 | User Manual
17
WaRninG
Never remove the bored piece until the boring cycle is complete.
7.3 Applications
Joining at 90º
Joining at 45º Using 45º Fence
Step 13:
Boring the Workpiece
WaRninG
Do not attempt to operate machine if you are not completely familiar
with its operation. Obtain immediate advice from a supervisor,
instructor, or other qualified personnel.
Use of this machine requires that you give your work your undivided
attention, and careless acts or not paying close attention to work
being performed may result in serious injury to yourself and/or
others. Never operate this or any machine under the influence of
drugs, alcohol, or any medication that may impair judgment.
Do not bore warped workpieces. The workpiece must sit flat on the
table without rocking.
Dust created by manufacturing activities may be harmful to your
health. Your risks from exposure may vary. Always work in a well-
ventilated area and wear safety approved, protective dust masks
specifically designed to filter out microscopic particles.
1. Turn on air supply and power supply to machine.
2. Place the workpiece in the desired reference position against
the fences and/or flip stops.
3. Bore your workpiece:
a. If in manual mode, press the Start button to begin drill
rotation, then depress the foot pedal to process boring
work; the drill spindles will run continuously, even in the
lowered/back position. Press the Stop button to stop drill
rotation.
b. If in automatic mode, press the foot pedal; the drill spindles
will run automatically when the boring head carriage moves
up/forward and stop when it returns to the lowered/back
position.
4. Remove the workpiece.
