Ironwood BR23 | User Manual
9
3.5 Remove Machine from Pallet
Caution
The BR23 weighs approximately 830 pounds. For this procedure,
we recommend using four people or a forklift.
TOOLS REQUIRED:
• Adjustable wrench
When the machine has been placed at its final location, carefully
remove the machine from the pallet.
The machine is
bolted to the pallet
for transport.
1. From inside the cabinet, remove the bolts that secure the
machine to the pallet at the interior corners.
2. Lift the machine from the pallet by one of 2 methods:
a. Team lift
b. Slide machine onto forks of fork lift
3. Carefully slide the machine into final position.
3.6 Level
TOOLS REQUIRED:
• Bubble Level
• Adjustable wrench
Use a bubble level along the length and width of the tabletop surface
to check for level. Use an adjustable wrench to adjust leveling bolts
to level the machine.
Be sure to level
the machine.
3.7 Pre-Operation Cleaning
WaRninG
Use proper cleaning agents and methods described below. Do not
use gasoline or other petroleum-based solvents. There is a risk of
explosion and burning if these products are used. Serious personal
injury may occur.
Machine Surfaces
After the machine is unpacked, remove the rust preventative oil that
coats the machine. Use a soft cloth and nonflammable degreasing
agent, such as Simple Green or other orange/citrus-based cleaner.
Do not use abrasive pads.
Boring Block Quick Chucks
Special care should be taken when cleaning boring block quick
chucks. Completely remove all the grease and dust using a
degreasing agent as mentioned above.
