Ironwood DBR50, User Manual

Ironwood DBR50  |  User Manual

7

3.0 Delivery and Installation

3.1 Receiving Your Machine

You will be contacted to arrange delivery. Your machine will be 
delivered by truck to your location. If there is no loading dock, be 
sure that you have informed the carrier in advance so that they 
deliver using a truck with a lift gate to lower the machine to ground 
level. 

Before accepting the machine and signing the bill of lading from the 
carrier, please inspect crating and machine condition, note potential 
damage on the bill of lading, take pictures of potential damage, and 
contact Stiles Machinery immediately at 616.698.7500 and ask to 
speak with the traffic department.

The machine will arrive fully crated and secured to a pallet. Use a 
hand truck or fork lift to move the machine on its pallet as close to 
its final position as possible. 

If you do not intend to install the machine immediately after delivery, 
store it in a protected, cool, and dry location. 

The machine arrives fully crated. 
Remove and save the paperwork 
attached to the outside.

3.2 Unpack the Machine

TOOLS REQUIRED:

•  Hammer
•  Crowbar

Unpack as follows:

Do not remove the machine from the pallet.

1.  Remove and save all paperwork attached to the outside of the 

crate.

2.  Remove the crating, starting with the top, then remove the four 

sides. Use caution to avoid personal injury and prevent damage 
to the machine’s finish. 

3.  Remove the protective plastic from the machine, starting at the 

bottom.

0

0 0

0 0

0

0 0

0 0

0

0 0

0 0

Do not remove the machine 
from the pallet while uncrating.

4.  Remove hardware, accessories, and tool kit that may be 

shipped inside the machine. If additional accessories are 
ordered, they may be delivered separately.