#1
A
B
H3
H3
H3
H3
H3
H3
H3
H3
H3
H3
Screw in Rafix Bolts (H3) into corresponding holes.
H3
ASSEMBLE
DISASSEMBLE
Using the Rafix System:
Insert the Rafix Cams into the
appropriate holes. The flat edge of
the cam should be facing the edge
of the panel.
Slide Rafix Cams of the panel to be
attached onto the corresponding posts.
Using a #3 Phillips screwdriver, turn the
rotating portion of the Rafix Cam a 1/2
turn clockwise to secure.
IMPORTANT!
Do not exceed 1/2 turn when tightening
cams.
Turn 1/2 turn counterclockwise
to disassemble and remove panel.
When screwing post
into hole,
Do Not
over tighten. Screw
post down until
bottom face of post
flange just touches
board surface.
Flat
edges
must be
aligned
