4.5
The function DATA MEMORY (Memory Mode)
7-day data memory (STEP)
(at the bottom, instead of the time, the display shows -1 DAYS RECORD)
At midnight, the PE109 automatically saves the accumulated data (Chapter 4.1 to 4.4) for the respective
day.
Select the day: with the RESET key (‘-1’ is yesterday, ‘-2’ the day before yesterday, etc.)
Select the measurement data: with the SET key
If the memory is empty, ‘zero’ is displayed.
You cannot delete the memory data individually. Only via total deletion in the TOTAL STEP mode.
4.6
The function TOTAL STEP
Totalizer for all measurements (TOTAL STEP)
The measurement data added since the last complete RESET are collected here.
Select the measurement data: with the SET key
Complete reset (RESET) of the measurement data
Press and hold the RESET key for at least 4 seconds. All measurement data are then deleted, including the
data in the daily memory!
5.
Change / activation of batteries
- The cover of the battery compartment is located on the reverse of the device. You can use a coin to open
the battery compartment (turn in anti-clockwise direction, as the arrow in direction ‘OPEN’).
- With a new device, open the battery compartment and remove the insulating strip.
When using a device with a discharged battery, replace the old battery with a new one, type CR2032 (3V).
Please ensure correct polarity (the positive pole upwards, i.e. visible for you when you insert the battery)!
- Close the battery compartment again (replace cover and then turn gently in clockwise direction). The two
dots (on the left of the cover next to ‘OPEN’) and on the casing must be adjacent, as illustrated above.
