background image

Materials 

  

Steel.

Packaging 

  

Polythene wrap and boxed

Voltage-feed 

 

   

 

230V 50Hz, 1ph

Insulation Class

  

 

  II

Protection degree

  

  IP44

Length electrical cable 

  

 

1200mm

Electronic ambient thermostat with “pilot wire” control 

The association between electrical heater and the radiator model allows a radiator surface 

temperature no higher than about 70°C.  The Towel Warmer is filled in the factory with a measured 

quantity of a special liquid, to optimize the heat transmission. Because of this, any repairs which 

require the opening of the towel-rail, must be executed from the manufacturer. This applies equally 

in the unlikely event of the special liquid leaking out of the towel-rail.

All products must be inspected once removed from the packaging and The Radiator Company notified 
within 28 days of delivery of any scratches, blemishes or other damage. The Radiator Company will then 
replace the radiator. 
Imperfect radiators should therefore not be fitted and The Radiator Company will not accept responsibility for 
replacement of scratched or damaged radiators once they have been fitted. This includes any consequential loss 
or cost of fitting.
If The Radiator Company are not notified within 28 days of the date on the signed delivery note then it will be 
deemed that The Radiator Company have fully complied with its obligations and claims will not be considered.
Failure to comply with any of the above may invalidate any claims.
We recommend that after you check the product on delivery that it is stored in its packaging to prevent damage 
prior to installation. The Radiator Company cannot accept responsibility for items damaged after delivery.

Terms & Conditions

Guarantees & Liabilities

The Lupin towel rail is guaranteed for 10 years, the electric parts for 2 years. The guarantees in 
all cases are subject to the products being installed in accordance with British and or European 
standards as well as these fitting instructions. The guarantees in all cases are restricted to the free 
of charge replacement or repair of the failed product only. Our liability will under no circumstances 
extend beyond the repair or replacement of the product supplied by us. Claims for either labour in 
replacement or damage to property are not admissible. Any goods that are returned, in the event 
of a problem, will belong to The Radiator Company.

Technical Specifications

Please read these instructions and terms and 
conditions carefully prior to installation. 
Failure to do so may invalidate the warranty.

Lupin Electric 

Fittings Instructions 

LUP_ELE_1.0

THE 

RADIATOR

COMPANY 

The Radiator Company
Units 13 - 14 Charlwoods Road
East Grinstead
West Sussex
RH19 2HU

Cod. 1180M1019

Maintenance - Recommendations for use

• 

This radiator should be cleaned regularly, particularly when in use (at least once a month).  

 

Switch off at the socket before cleaning the radiator. Clean it using a non-abrasive product  

 

and  a soft cloth. 

• 

If you wish to open the window, it is advisable to switch the radiator to standby to save wasting energy.

• 

If you encounter any problems or the radiator needs to be repaired, do not do this yourself;  

 

Please contact The Radiator Company. 

If you have any questions please contact us: 01342 302250, www.theradiatorcompany.co.uk

A brand of                , Italy’s leading manufacturer of design led radiators

Reviews: