Transportation of the machine:
Attention:
DANGER!
Before transporting the machine, turn off the engine and wait for the cutting tools to come to a complete
halt. The machine must be fastened according to the regulations in four directions. When driving the
machine outside of the working area, the attachment must likewise be switched off and the cutting tools
come to a complete halt.
Steering:
The
IRUS UNITRAK
is so designed that it always has the tendency to go straight ahead. Do not try to control
the machine forcibly at the steering bar. This is not necessary because the machine has an active steering
system.
The active steering system:
If you want to turn right, you only need to press the steering bar to the left and the machine moves to the
right. By
pressing the steering bar to the right, the machine moves to the left. Depending on how hard
you
press, the machine turns sharply, even with a jerky motion, or it moves gently into the curve. As soon as
you leave off from pushing to the sides, the machine drives straight ahead again.
WARNING!
Always work slopes going uphill only! RISK OF ACCIDENTS!
Moving the centre of gravity:
To be able to drive the machine comfortably while using various heavy attachments, the
IRUS UNITRAK
has
an adjusting axle.
If the axle is moved forward, the weight is shifted backwards, i.e. the pressure upon the mounting device is
less. The attachment can be lifted with less force upon the steering bar. If the axle is moved all the way
back, it is just the opposite. For every attachment, you need to choose the most convenient position.
Adjustment of the axle:
01. Loosen the four Allen screws on the right and left (Figure 4/2).
02. Operate the control lever (Fig. 2/5) in the direction in which you want to adjust the axis.
03. Torque up the four Allen screws again, right and left.
Summary of Contents for unitrak
Page 1: ......
Page 16: ...Figure 7 1 Grease nipple ...