10
Irvine Tutor
40
II
11
Irvine Tutor
40
II
I.C. Engine Installation
(A) Low Throttle
(B) Mid Throttle
(C) High Throttle
Connect the fuel feed pipe
to the engine’s carburettor
or remote needle valve as
shown here. Connect the
pressure pipe to the engine’s
silencer, then fit the silencer
with the screws supplied
with the engine.
Stage 5
5.1. Connect the fuel tube
5.2. Connect the pressure tube and install the silencer
LOW
Throttle
Stick
Position
MID
Throttle
Stick
Position
HIGH
Throttle
Stick
Position
Stage 7
It is vitally important that the throttle operates correctly and does not bind at either end of its
travel. Switch on the radio and centralise the throttle stick. Holding the throttle barrel at its mid
throttle position, nip the grub screw tight in the pushrod connector. Use your transmitter’s end point adjustment - EPA/ATV
- (or adjust mechanically) so that the throttle opens and closes as shown in the diagrams below
Stage 6
Remove your engine’s prop nut and washer. Install the spinner backplate followed by your
propeller. Use the moulded pegs to align the propeller so that when the propeller is in the
correct position, the spinner cut-out will align correctly with the propeller. Re-fit your prop washer and nut, then tighten. Fit
the spinner nose with the two screws supplied.
6.1. Fit the spinner backplate
6.2. Fit your propeller and tighten
6.3. Re-fit the spinner nose
