iRZ MC52i-485GI, User Manual

13 

The modem automatically stores the number of the following situations: 

Power_Modem

 or the number of times the modem has been turned on 

Bad_Power_Modem

 or the number of times the modem power has deviated from the allowed 

Power_Module

 or the number of times the power of the GSM module has been turned on 

Bad_Power_Module

 or the number of times the GSM module power has deviated from the allowed 

Start_Module

 or the number of the successful launches of the GSM module 

Bad_Start_Module

 or the number of situations when the GSM module failed to launch 

Deadlock_of_Module 

or  the number of GSM module deadlocks

Reset

 or the number of resets. 

After the statistics appears the transition to the main menu occurs. 

Use <

P2

> command to proceed to the WD submenu: 

WD interval, hour (0 - WD off, max - 255) 

<Q> Quit 

WD interval= 

To change the reboot interval, enter a number from 0 to 255 (by pressing “Enter”). The reboot interval is set 

in hours. If you need to switch off this function enter 0. Keep in mind that after the set interval expires, the 

unconditional reboot of the modem will occur. In case incorrect information is entered the modem displays 

“ERROR” and offers the WD submenu once again. In case correct information is entered or <

Q

> command is 

sent a transition into the main menu takes place. 

Use <

P3

> command to proceed to the AT submenu: 

'AT' control, minutes (0 - off, max - 255) 

<Q> Quit 

control= 

In this submenu the interval of the periodical check by the managing microcontroller of the GSM module 

deadlock is set. To change the interval of the check enter a number from 0 to 255 by pressing “Enter”. The 

reboot interval is set in minutes. If you need to switch off this function enter 0. In case incorrect information is 

entered the modem will show “ERROR” and will offer the AT submenu once again. In case correct information 

is entered or <

Q

> command is sent a transition into the main menu will take place. 

After entering the <

PC

> command review the input voltage and the voltage of the module (measurement 

precision 5%): 

P0WER   Uin=12.0   Umd=3.9 

After the output a transition into the main menu occurs.