9
F
RONT
P
ANEL
E
LEMENTS
C
HAPTER
5
RAPTOR P
ANELS
D
ESCRIPTION
5.1. Front Panel Elements
Figure 2:
Front Panel Elements
1)
SD Card
port may be used to store Syslog files. SD#1 (top) is disabled by default. SD slot #2 (bottom)
is available for customer use.
2)
Management Port
—this 10/100Base-T Ethernet port is used as an out-of-band factory service port.
It is disabled by default and not available for user access.
3)
RS232 Serial Console Port
—this port is for interfacing directly with the device and accessing
management functions via serial interface.
4)
USB Port
can be used to upgrade or back up the Raptor's software or configuration files.
5)
Power Status LEDs
—the light-emitting diodes (LED)s indicate the status of the power supply
modules.
6)
Power Supply 2 (PS 2)
—both power supplies may be used for redundancy
7)
Power Supply 1 (PS 1)
—both power supplies may be used for redundancy.
8)
Reset Button (Not Shown)
—The Reset button is found directly under the USB Port. By pressing the
reset button then releasing it, the iMX950 will reboot. By holding it for over two seconds and then
releasing it, it will be possible to access debug functions on the console terminal. These debug func
-
tions should only be accessed in consultation with the iS5Com support team.
