TROUBLE
CAUSES
TROUBLESHOOTING
Air does not
come out from
the tool.
The tank in
not under
pressure.
Switch on the machine and
wait until the tank is loaded
verifying the pressure on
the proper pressure gauge.
Wrong
adjustment
of the output
pressure.
Check that the value
indicated on the pressure
gauge at output is greater
than 0 (zero) bar.
The tool is
damaged.
Check the integrity and
efficiency of the tool.
Pressure
decrease in the
air tank.
Leaks from
the air tube,
the tool or the
pneumatic
plant.
1.
Check the integrity of the
pneumatic plant.
2.
Check the integrity of the
air tube and of the tool.
3.
Verify that the machine
air tube and air tube tool
connections are right.
4. Make sure that the
condensate drain valve is
well closed.
Tripping of the
safety valve.
Pressure
switch faulty.
Apply to an
authorized dealer.
Air leak from
the valve of the
pressure switch
with stopped
machine.
Check valve
dirty or worn.
The machine
vibrates and/
or emits a lot of
noise.
Mechanical
break.
Frequent starts
and low yield.
Air filters
dirty.
Clean the filters.
PACKAGING
SPARE PARTS
Original spare parts for possible replacements are to
be requested exclusively to the manufacyurer or to the
authorized dealer.
It is strictly forbidden to replace any components of
the machine with non original spare parts.
PACKAGING
The machine is packed by the Manufacturer in a cardboard box
equipped with two handles and containing No. 1 Dry compressor
and No. 1 Use and maintenance instructions.
UNPACKING
Once the package has been positioned on the floor, on an even
surface assuring its stability, unpack the machine removing it from
the package observing the instructions contained.
STORAGE
If the machine is not used for a long time, it is neces-
sary to store it in a safe place, provided with proper
temperature and humidity, as well as to protect it
against dust.
Before storing the machine, it is recommended to drain
the condensate from the air tank.
It is recommended to dispose the package according
to the different types of materials in full observance of
the laws in force in the country of use.
Ain order to allow the authorized operators to work
in safe places, it is suggested to assure a minimum
distance (1 m) from others, objects and/or obstructions.
POSITIONING
The machine must be used in a work place having
the features described, positioned on an even floor
assuring its stability relation to its overall dimensions
and weight.
bar
0
The transport of the manchine must compulsorily be
carried out by two charged operators in compliance
with the regulations on the “manual handling of
loads”, in order to avoid unfavourable ergonomic con-
ditions that may involve risks of spine/lumbar lesions.
MACHINE TRANSPORT AND HANDLINGT
The machine can be transported manually by two charged
operators by seizing it by the bearing foot and the handle
or handled manually by a charged operator using the
handle and the wheels with which it is equipped.
bar
0
9
EN
