5 Operation and maintenance
The following safety instructions are intended to ensure the personal safety of the user. operating personnel as well as the safety
of the product described and of the devices connected to it. Failure to observe the safety regulations and warnings can result in
serious bodily injury or death and damage to property.
Before operation and connecting to mains, please make sure, that all cables are connected and airflow is not impeded. The case
must not be covered and installed properly. For installation in a rack, forced cooling must be provided. After turning on the mains
switch of the crate, the controller will start up in standby mode. For more details and handling please read the corresponding
manual.
6 Configuration of the HV-Modules slot position
The slot positions of the HV modules in the crate is preconfigured by the factory. This configuration has to be stored in the
firmware of the controller board and may be changed through a hardware switch on the backplane. If its necessary to change HV
configuration, please
, in order to get the correct encoding.
7 Compatibility lists
MMC CRATE CONTROLLERS
NOTES
MICC controller
As of firmware 4.xx
MMC HIGH VOLTAGE MODULES
NOTES
CPS 3U-series
DPS 3U-series
EPS 3U-series
60 W version only
MMS-3U HIGH VOLTAGE MODULES
NOTES
EBS 3U-series
ECH 124 / 128 / 12A / 14A - MMC Crate | Last modified on: 24.01.2020 | www.iseg-hv.com
11/20
