Iseki 1812001, Owner'S Manual

7

546336.B.9

Original version

ENGLISH

running. Allow engine to cool before refueling. Do not 

smoke while refuelling.

c)  Never refuel the machine indoors.

d)  Never store the machine or fuel container inside 

where there is an open flame such as a water heater

e)  Always replace & securely tighten the fuel cap after 

refilling.

f)  If fuel is spilled, do not attempt to start the engine, 

but move the machine away from the area of spillage 

before starting.

5.  Check the amount of oil and fuel before operation

6.  It is recommended to do a run test to make sure connecting 

parts are firm. (For detailed information please refer to the 

engine instruction manual.) 

7.  After testing the machine it is recommended to gradually 

increase the loading. 

8.  If the machine makes abnormal vibration or unusual noises, 

immediately turn the machine off and get it checked by an 

authorized person.

9.  If there is many uncut materials it shows that blades may be 

need to be sharpened or intervals may need to be adjusted. 

Take the machine to an authorised dealer to sharpen/install 

new blades. 

10.  If the cutting mechanism strikes any foreign objects or if the 

machine should start making any unusual noise or vibration, 

immediately shut off the engine and allow the machine to 

stop. Disconnect the spark plug and take the following steps:

1) Inspect for damage

2) Replace or repair any damaged parts

3) Check for and tighten any loose parts.

Assembly

All bolts, washers and nuts have been fixed at its original place 

inside the packaging.

This machine is large in volume, heavy in weight and it has many 

switches. When assembling the machine seek guidance and 

assistance from an authorised dealer or a person who has a 

considerable knowledge of this machine to ensure safety

Warning

In the process of installation, do not place hands or any 

other body parts within blade housing. Do not touch the 

blades with your hands or any other body parts.

1) 

Frame Installation

7

Number

Description

1

Wheel

2

Bolt

3

Bolt

4

Wheel Axle

5

Bolt

6

Front Shock pad

7

Belt Cover

8

Base Frame

9

Engine

10

Drum

1.1 Assemble the Wheel Axle (4) on the Base frame (8) using Bolt (5) 

with Nut and washer.

1.2 Fix the wheels (1) as shown in the picture on wheel axle by 

using bolt and washer (2).

1.3 Attach Front shock pads (6) on the Base frame using Bolt (3).

Warning

In the process of installation, do not place hands or any 

other body parts within blade housing. Do not touch the 

blades with your hands or any other body parts.

2) Handle and Hand Wheel Installation

11

11

No.

Description

No.

Description

11

Bolt

20

Sleeve

12

Inlet Chute

21

Bolt

13

Outlet Chute

22

Spring

14

Rear Shock Pad

23

Interlocking Switch

15

Blade Housing

24

Knob

16

Bolt

25

Handle 

17

Locking Pin

26

Hand Wheel

18

Safety Bar

27

Bolt

19

Bolt